Usually, the location of the reset button on a furnace stands out. One can easily spot it as it is painted in bright red or yellow for easy visibility. The location of the reset button might also depend on the location of the blower motor. If the blower motor is on the front, then you can easily spot the reset button. But if the blower motor is located on the back or the sides of the furnace, then you might have to move the furnace around a bit to reach the reset button. One can easily locate the reset button on the furnace because it is half an inch above the furnace’s surface.
The location of the reset button might also depend on the make and model of the furnace. Different companies often bring out furnace models which are completely different from their counterparts, making it a bit tough to spot the reset button. Always refer to the manual, in this case, to look for the reset button and you can contact our furnace repair in Lake Dallas team of experts to know more about this issue.
What Does The Reset Button Do?
The reset button usually makes it possible for the furnace to heat your home safely. It trips when there is a fault in the furnace or when the furnace overheats. It trips to keep the circuit breaker safe. Also, it is crucial to maintain the safety of the furnace.
It is an important part of HVAC systems. It is not unusual for reset buttons to trip regularly, but a professional should always be consulted when the reset button trips regularly because it might indicate a fault in the furnace.
When Does The Reset Button Trip?
The reset button usually trips when the furnace detects a fault in the equipment or when the furnace overheats. Problems like lack of fuel, dirty air filter, dirty flame sensor rod, a glitch in the control panel, blocked gas valves et cetera trigger the tripping of the reset button. The furnace trips the reset button as soon as the fault is detected, preventing any further damage from happening due to the gas.
How To Use The Reset Button?
Reset buttons are fairly easy to use. They do not require a lot of maneuvering or technical knowledge. You can follow these simple steps to use the reset button in a furnace –
- You should check the pilot light first and see if it is on.
- You need to turn down your thermostat to the lowest setting.
- Now, turn off the furnaces’ power supply.
- Turn off the main gas supply to the furnace but keep the pilot supply on.
- Relight the pilot flame now by holding a match in front of the pilot flame jet.
- Now, turn ON the power, and then the gas supply.
- Now hold the reset button for approximately 30 seconds.
- Now you can raise your furnace to the desired temperature.
If these solutions do not help in resetting your furnace, then you should get an expert’s consultation as soon as possible. You can also look up ‘furnace service in Lake Dallas‘ on the internet and call our professionals.
For more information related to this visit our website now.
